1-800-221-0714
Timing Using a Manual Push-Pull Valve
Push-Pull valve can be used to start and stop system manually while providing timing to the circuit. A 4 way valve can also be used when operating a double acting cylinder, or for alternating outputs.
Compare / Request
up to 5 items
up to 5 items
| Item # | Operation | Typical Item Selection |
|---|---|---|
| item-1846 | Pushing in knob starts air flowing to device and to timer. When the timer reaches set time, it sends a signal to the reset port of the push-pull valve shutting down the air output. To stop the process, pull the knob out, shutting off the air and resetting the timer. | Any on delay timer (Consider length of time required and mounting preference). Push-Pull Valve- Cat. nos. 75022-27-22 (3way, 1/8 ports), 75023-27-42 (4 way, 1/8) or75043-27-42 (4 way, 1/4). Alternative-Lever operated valve, pneumatic reset, contact factory for information. |
- Ellis/Kuhnke Controls
132 Lewis Street Unit A-2, Eatontown, N.J. 07724
Phone: 1-800-221-0714
Fax: 732-291-8154
Email: Info@ekci.com
- Home Pneumatic Controls Technical Info CAD Drawings Contact Us Pneumatic Timers Blog Site Map
If you are looking for Pneumatic Controls, Pneumatic Valves then look no further than Ellis/Kuhnke Controls.