1-800-221-0714
Continuous Cycling Timer Circuit
Continuous cycling is accomplished by the use of 2 timers operating a spring return air piloted valve. Off and on times are dependent on the time range of the timers used. The size of the air piloted valve determines the air volume output.
Compare / Request
up to 5 items
up to 5 items
| Item # | Operation | Typical Item Selection |
|---|---|---|
| item-1850 | System pressure is turned on. Air flows through port 2 of Timer #2 to drive timer #1 and to operate the air pilot valve turning on air to the device being controlled. When timer 1 reaches set time, it sends a signal to port C of timer 2,shutting down the air supply to the air piloted valve and timer 1. This enables timer 2 to begin timing. When timer 2 reaches set time, it operates and the cycle is repeated. Removing the air supply resets the circuit to the start position. | One On Delay PT timer and one Off Delay PT timer with the required time ranges. Single air piloted, spring return valve, 3 way, cat. no. 75026-71-21 (1/8), 75046-71-21 (1/4), 75066-81-21 (1/2). For operating double acting cylinders use 4 way valves. |
- Ellis/Kuhnke Controls
132 Lewis Street Unit A-2, Eatontown, N.J. 07724
Phone: 1-800-221-0714
Fax: 732-291-8154
Email: Info@ekci.com
- Home Pneumatic Controls Technical Info CAD Drawings Contact Us Pneumatic Timers Blog Site Map
If you are looking for Pneumatic Controls, Pneumatic Valves then look no further than Ellis/Kuhnke Controls.