Shop
1-800-221-0714
Fax: 732-291-8154
Email: Info@ekci.com
sales@kuhnkeusa.com

Directional Control Valves, (4 Way), Pneumatic Actuation (Poppet Design, In Line Mounting)Item # 75067-81-47

Pneumatically operated poppet valves are available in single, double or with priority port actuators. The priority port design overrides the signal from the opposite pilot operator to insure return to home position. Poppet valves rely on O rings and gaskets to seal passage ways within the valve and generally offer higher flow rates than other types of valves.

These valves are available in port sizes of 1/8, 1/4 and 1/2. Pilot ports are 1/8 for all size valves and require minimum of 35 PSI operating pressure. Single air pilot valves have an air supported spring return and require a pilot pressure equal to or greater than the air supply pressure at port 1. Valves can be mounted using through body holes or assembled on manifolds.

Pilot port size (for actuation): 1/8 for all size valves.

Operating pressure range 35 to 145 PSI. Actuation force (pilot pressure): 35 PSI minimum.

Mounting via 4 through body holes 3/16” Dia. (1/2” ported valves- 1/4” Dia.).

For valve specifications see appendix. See accessory section for manifolds if required. For detail dimensions contact factory.
Item #75067-81-47
DescriptionDouble Air Pilot With Priority Detent
Port Type1/2 NPT Ports (USA Std.)
Orifice0.59 in.
15 mm
Body No.12P
Length6 3/4 in.
Width1 5/8 in.
Height2 3/4 in.
Body Mounting Hole1/4 in.
Operating Pressure Range35 to 145 psi
Cv4.83
Kv68.8
Flow @ 45 PSI129.4 SCFM
Flow @ 90 PSI227.1 SCFM
Flow @ 145 PSI359.0 SCFM
Flow @ 3 Bar3665 lpm
Flow @ 6 Bar6430 lpm
Flow @ 10 Bar10165 lpm
Intended Use- Series 75 and 76 valves are intended for general purpose industrial applications utilizing normal shop air supply systems. For special applications with other media or other environments, contact Kuhnke.

Media- Compressed air or other neutral gases, properly filtered. For applications on liquids contact Kuhnke.

Lubrication- Valves operate on lubricated or non-lubricated systems. After using components in a lubricated system, do not switch to an un lubricated system. Avoid over lubrication.

Vacuum Applications- Spool Valve designs can be applied on vacuum systems. For applications using poppet valves, use only specially assembled valves shown in the catalog.

Dimensions and Design Changes- All dimensions in this catalog are approximate, if necessary, detailed drawings can be obtained from Kuhnke or from one of the Kuhnke websites. Dimensions, valve design and materials are subject to change without notice.

Metric and NPT threads- Although similar in size, valve port threads in metric ported valves are different from NPT versions. NPT versions have a tapered thread that is used to form a seal with the fitting thread. Metric thread is straight, and the seal is provided by an o-ring or washer normally included with the connection fitting. Metric fittings can be used on NPT threaded valves, but NPT fittings cannot be used on metric threaded valves.
  • 1/8 Ported Double Pilot Type 76127
    1/8 Ported Double Pilot Type 76127


If you are looking for Pneumatic Controls, Pneumatic Valves then look no further than Ellis/Kuhnke Controls.